Prosystemaqua - Controller Plus - PH & EC - 4 Pumps

Continuous flow pH / EC controller

Allows to have a pH / EC always at the right value.
Indicates the values of pH / EC and regulates continuously, for a precise adjustment of the water.
Controls automatic filling of tanks, recirculation pump, irrigation pump, water temperature.

Information about the Prosystemaqua Control Plus:

• Works with multiple systems: Hydroponics, aeroponics. In aquarium or vertical flow.
• Pumps are independently controllable: Flow rate from 0 to 4 L/h.
• 2 independent irrigation programs: Irrigation pump and water recirculation pump.
• It is possible to connect a heating or cooling system, for a control of the water temperature.
• Automatic triggering of the water filling, by means of a probe activating the filling solenoid valve.
• The controller is held on a methacrylate plate, where the water inlet can be connected, as well as the outlet pipe of the recirculation pump.
• The impurity filter helps to maintain the accuracy of the pH /EC probes.

Operation:

The controller requires configuration prior to operation

• pH:
  Enter the desired value in the water container.
  Set the pH mode to down or up.
  Proceed with calibration.
  Adjust the proportional flow rate of the Ph pump.
  
  
• EC:
  Enter the desired EC value in the water container.
  Check temperature compensation, time and air alarm.
  Proceed to calibration.
  Adjust the proportional flow rate of pumps A and b.
  

• Water recirculation:
  Once the water recirculation pump is connected to the controller, program the desired sequences and times.
  
  
• Irrigation system:
  Once the pump is irrigation system in connection with the controller, program the desired sequences and times.
  
  
• Filling system:
  The placement of the level probe, is positioned in the water supply
  
  
• Temperature control:
  Once the cooling or heating system is connected to the controller, set the desired water temperature.

• Measurement and conductivity pH:
  The probe allows detection of the conductivity and determines the value and transmits it to the display of each pump.
  
  
• Fertilizer suction and pH control:
  The controllers inject the product into the suction filter, and regulate the pH and EC.
  
  
• Fertilizer injection:
  Once the EC and pH values are indicated in the controller, the distribution of fertilizer and pH through the injection valves of the collector, adjusts the values in the water container.

Photo not contractual.