MODULO GREEN - VERTICAL PLANT WALL - 60X43CM - WITHOUT SUBSTRATE

ModuloGreen, the vertical solution for creating green walls

The patented technique Modulogreen® vertical solutions offers you alveolar modules that allow the creation of green walls inside and outside.

The concept of vertical vegetation Modulogreenoffers about 4Litres/plant of substrate, which is favorable to the root development of plants.

Principle of ModuloGreen

• a: Self-regulating pipe clip
• b: Seal
• c: Holes for module fixation
• d: Planting openings
• e: Filter
• f: Specific culture support

Dimensions of Modulogreen 60cm long

Installation of the Modulogreen

The modules are fixed on an aluminium structure anchored to the wall which will be used as support. This allows to create an air gap between the wall and the plant complex, to avoid any risk of contamination of the support.

To get aluminum structures, please visit our Moldable Structure category.

• a: Aluminum bracket
• b: Stainless steel self-drilling screw
• c: Stainless steel anchor bolt
• d: Aluminum profile
• e: Stainless steel self-drilling screw + EPDM seal

Modulogreen irrigation system

The internal movements of the modules allow to distribute the water supply homogeneously in the whole available substrate, optimizing considerably the water consumption of the system (average consumption of the process Modulogreenvertical solutions: 220L/year/m²).

• a: Self-regulating pipe
• b: Layer separation filter
• c: Drainage layer
• d: Evacuation of excess water
• e: Internal movements for water distribution
• f: Cultivation support
• g: Gutter for the recovery of excess water

Hydraulic distribution of the green wall

• a: Amanded water inlet
• b: Self-regulating pipe
• c: Peripheral cladding
• d: Drain valve
• e: Evacuation of excess water (waste water network)

The irrigation of the green wall requires a water supply dedicated to the installation. Depending on the case, a rainwater reserve can be used to supply water to the installation. The pressure and the flow rate will depend on the characteristics of the project (surface, number of networks, pressure losses linked to the installation of the technical room and the green wall, etc...)