Lumatek - Electronic ballast 400W+ DIMMER , transformer , digital ballast [refurbished]

Switch super lumens" positions (possible variations of light intensity): 50%-75%-100%-110%

This Digital NXE ballast Lumatek MH / HPS digital ballast is the most efficient of all the electronic ballasts on the market.
The Digital NXE ballast Lumatek digital ballastdelivers an average of 26% more light than a conventional magnetic ballast (DUO ballast, Combikit, etc.) and is 10 to 15% brighter than other competing digital ballasts.

The NXE digital ballast Lumatek MH / HPS 400 Watts ballast with an integral aluminum housing is equipped with several microprocessors (GIP) modulating the power emitted by the ballast according to the type of bulb detected (HPS / MH). Thanks to its GIP technology, it can increase the luminous flux of the bulb to maximize its performance.

- 26% more luminous flux than a classic magnetic ballast,
- 10 to 15% more luminous flux than a competitor's digital ballast,
- Compatible with all MH and HPS bulbs of adapted power present on the market (without distinction)
- Consumes less energy than a magnetic ballast thanks to a reduction in heat loss (heat emitted by the ballast),
- Increases the life of the bulb and maintains its luminous flux over time,
- Thanks to its progressive start-up, no need to use relays or circuit breakers to protect your electrical installation,
- Thermal protection turning off the ballast in case of short circuit,
- Minimal RF interference (range less than 50 cm). A poorly made ballast can generate RF interference up to 45 meters (Interference that can disturb your other electronic devices).
- The aluminum casing of the Digital NXE ballast Lumatek ballast is completely sealed with resin. This will protect your turntable from any unwanted splashes.
- Low weight of the ballast thanks to the absence of copper coil.
- 3 years warranty (5 years with extension)

This Digital NXE ballast Lumatek digital ballast is equipped with high quality components and the best technologies (GIP) of the moment providing you with unparalleled high-end performance.
This model benefits from an unequalled quality of finish and consequently does not require any additional assembly or wiring on the part of the user (except for the connection of the reflector socket).

Included:
- A Digital NXE ballast Lumatek 400 Watts MH / HPS fully enclosed,
- 1.3 meters of pre-mounted mains cable,
- 2.3 meters of pre-mounted bulb cable to the ballast.

- The power supply is adapted to the technology and the power of the HPS bulbs of 400 Watts => Do not use it with bulbs of another power,
- Power supply of 400 Watts used for the lighting of a surface of 1 m²

• Electronic ballast for 400W HPS or MH bulb

• Voltage : 230V 50/60Hz

• Current : 1.80A

• Input power : 415W

• Output power : 400W

• Efficiency : >0.99

• Voltage : 165 to 265V

• THD : <10% (1)

• CCF Lamp : <1.7

• Operating frequency: high frequency

• No audible noise, no flickering

• Ambient temperature : -25 to 50 °C

• Internal temperature rise: 29 °C

• IP compliance: >IP23
  
  

IEC MALE SOCKET NOT SUPPLIED, AVAILABLE AS OPTION (to connect the ballast to the socket).