Timer Super Switch Box 4, cultivate 2 spaces

This revolutionary timer switch is suitable for 4 lamps but you only need 2 ballasts and 2 bulbs on 2 reflectors.

This timer switch allows you to have a grow room with 2 lamps powered by the same ballast; and by using a second ballast of the same power (as the first one), you can light a second grow room with 2 different lamps as well.

Save 50% on the purchase of ballasts: you only need 2 ballasts to power 4 bulbs on 4 reflectors!

A very innovative product from SuperPlant !!!

Warranty: 1 year .

Metal box with 6 IEC connectors: two IEC male to connect the 2 ballasts (electronic or not), four IEC female to connect the four bulbs (of the same power as the two connected ballasts).

INFORMATION

Setting of the device :

WARNING: The device must be permanently connected to the mains. It takes a few minutes of connection before the Quartz timer starts.

In Auto position

Allows you to set the current real time (hours on the dial, minutes in the small window).

In 45° position (if in horizontal or vertical position, turn it one notch in the direction indicated by the arrow so that it is at an angle, as in the photo).

Notches circled in purple (1 notch = 30 minutes):

Pushed outward = timer ON

(lamp A is on when the timer is in the OFF position, lamp B is on when the timer is in the ON position)

In this position (setting visible on the picture), lamp B is on (timer in ON position), when the dial will have turned according to your setting, the notches will turn the knob green by 45° and put it in OFF position, the power will switch to lamp A, and so on.

NOTE: the switchover is not instantaneous, a delay of 1 to 2 minutes can be observed between the extinction of the first lamp and the lighting of the second.

CAUTION: Works with magnetic ballast. For electronic/digital ballasts, they can be put in safety at the time of the switch (interpreting it as a failure of the bulb, it cuts, it is then necessary to disconnect and reconnect the ballast to reinitialize it and relight the lamp). In this case, you have to add a timer before the ballast, program it to turn off the ballast 5 minutes before the switch is made on the second lamp, and turn it on again 5 minutes after the switch is made. And apply the same procedure for the switch in the other direction.

Know how to plant without crashing!
Culture Indoorthis is the preferred choice of all growers for indoor cultivation.